Thingiverse
Drone Wall mount remix
von JCFPV2022
12
Downloads
9
Likes
0
Makes
This is a remix i did from dudufreeride I just made it thicker on the z axis from 23mm to 30mm i was worried it would possible break when looking at the infil i also increased the infill to 40percent and printed it at .18 with a 60mm per second speed use pla+ from esun. I am a beginner and trying to post my remixes to donate to the cause.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
