Drop Box Lid-Half

Print two to make the full lid.

This is meant to be used with the following storage container from Walmart.
https://www.walmart.com/ip/Mainstays-9-Cup-Rectangular-Food-Storage-Containers-3pk/50003594

It makes for a fairly large quadcopter or hexacopter. I'm using it on a Tarot 650 Ironman. I tend to drop light candy (i.e. salt water taffy, smarties, etc) or parachute figurines. I've also dropped heavier candies with it using streamers to slow them down.

The hooks for the rails on the Tarot can be found here:
https://www.thingiverse.com/thing:528353

The servo mount I used can be found here (I used two servos on this one, but it seemed to work fine with just one):
https://www.thingiverse.com/thing:1926568

The hinges I used were a remix of these:
https://www.thingiverse.com/thing:1096475

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/5bh5qPcphUI