drop side container (open and closed) Automatic locking

brief operational description (without any need for completeness) Due to the increase in the size of the hot materials, the previously used container was no longer suitable for long-term cooling, as the blanket layer no longer covered it properly, and as a result, the cooling time was faster than expected After several months of thinking, I was able to start the design, as there were a lot of technological and geometrical parameters that had to be met: I. General Requirements The container must be equipped with a specific system The container must be designed for storage of approximately 2000 units The container must be adaptable to specific storage conditions II. Handling and Transportation Containers must be stored on rails Containers must be able to be moved using a trolley and crane Containers must be easily accessible during loading and unloading III. Functional Requirements The container must have both storage and loading/unloading functions The container must be able to be quickly closed The container must be designed for use in high-temperature environments The container must be resistant to heat stress and thermal shock The container must be able to be walked around during filling The container must not require maintenance The container must be stackable IV. Safety and Ergonomics The container design must ensure good ergonomics and prevent finger pinching The door must not be too heavy The container must meet work safety requirements V. Common Requirements The container design must prioritize simplicity and cost-effectiveness Where possible, the container component should perform multiple functions VI. Universal Application The container design must prioritize universal application, with each container equipped with the same system Each container must be equipped with the same system VII. Additional Requirements The container design must minimize the need for excessive modifications The container design must ensure compliance with work safety requirements