MakerWorld
Sculptures
Model downloaden
Drunk-O'-Lantern
6
Downloads
10
Likes
0
Makes
This model was printed on a Sunlu S8 at 30mm/s, 5% infill with a .2mm layer height. I used the custom supports, (arch-buttress) in Cura to place under the two higher teeth. You can find the custom supports plugin in the Marketplace in Cura which will be the Custom Supports Cylinder plugin.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
