Drybox pc4-m10 tap

Couldn't find a drybox tap I liked so I made my own.

I printed at 225 degrees. Apparently that temp creates the strongest prints for pla.

This needs a PC4-10 coupler.

To install drill a 8mm whole into container of choice. I believe this can be done one go with a brad point drillbit. If you don't have that than drill a pilot and keep getting bigger until you get to desired size.

Connect the PC4-10 plus the retainer. then use the nut to retain. You can use a 14mm wrench if you need more leverage.