Drying rack fix broken rods (parametric)

This parametric model is a simple part to fix a drying rag with broken rods, which is a common problem. It is designed to fit virtually any standard clothes drying rack. All key dimensions are fully adjustable, so you can easily tailor the model to your specific rack. Please share your makes in the comments :)! If you like this model, please consider giving it a boost.ParametersBar diameter (mm) → Diameter of the drying rack frame the hook clips ontoClothes rod diameter (mm) → Diameter of the rod used to hang clothesBottom extrude (0 / 1) → Clearance on the bottom for a welding spot on the frame1 = use if the hook sits over a weld0 = use if there is no weld (removes the hole on the bottom)No tolerances are added to the dimensions. If the fit is too tight or too loose, slightly adjust the values to your needs. Tolerances can vary depending on printer setup and calibration. The hole for the clothes rod has a taper angle of 0.1 ° to the inside, that the rod gets stuck securely.AssemblyPre