Drying Rack Wing Lock Clip

Hi 👋This clip is designed to lock the folding wings of a drying rack when it is stored in a vertical position, preventing them from accidentally unfolding.It solves a simple but annoying household problem — especially useful in small spaces where drying racks are stored upright against a wall.Print recommendationsRecommended material: PETGThis part is under constant stress during use.PLA may become brittle over time and can crack, especially if the clip is frequently installed and removed.Perimeters / walls: 4 walls recommended for better strength and durabilityLayer height: 0.2 mmInfill: 20–30%Supports: not requiredAdhesion tip: if you experience bed adhesion issues, adding a brim is recommendedFit & compatibilityDesigned for round tubing with a diameter of 12.5 mmFits standard foldable drying racks with similar arm geometry(tolerances may vary slightly between manufacturers)NotesFor best durability, print with good layer adhesionIf your drying rack uses a different tube diameter, sc