Thingiverse
Drywall hook
door nickyvdicarlo
1
Downloads
3
Likes
0
Makes
Basic hook designed to be used with drywall anchors/screws that I had left over from another project.
Recommend printing with the small hole facing down, using supports for the hook. Reason being is that with cubic infill the part seems strong enough to resist the bending loads on the hook itself, so my primary concern is it splitting at the layer lines where the screw goes in.
Pay attention to where your cooling fans point as well, since that will affect the print quality at the tip of the hook.
Recommend printing with the small hole facing down, using supports for the hook. Reason being is that with cubic infill the part seems strong enough to resist the bending loads on the hook itself, so my primary concern is it splitting at the layer lines where the screw goes in.
Pay attention to where your cooling fans point as well, since that will affect the print quality at the tip of the hook.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
