Thingiverse
DS18x20 plugable terminal case
4
Descargas
8
Likes
0
Makes
I made this for a DS18x20 "Plugable Terminal", it's exactly what it says on that board. The only Thing for same board I could find here seems a bit oversized for me.
It is a little hard to fit the case parts together for the first time, I recommend to place your device board into the bottom part, pressing on it slightly, then install the top part for close the box and press it down careful but firmly. It will also be useful to remove accidental protruding artifacts with a sharp blade before, if there are any, of course (I had not quite the right corners on my test model because I set the print speed too high).
If you need to open it again, place the blade in the gap between the top and bottom and carefully use it as a lever (only 2 mm deep).
v1.1 - The dimensions of the top part have been slightly reduced for easier closing and opening of the case.
It is a little hard to fit the case parts together for the first time, I recommend to place your device board into the bottom part, pressing on it slightly, then install the top part for close the box and press it down careful but firmly. It will also be useful to remove accidental protruding artifacts with a sharp blade before, if there are any, of course (I had not quite the right corners on my test model because I set the print speed too high).
If you need to open it again, place the blade in the gap between the top and bottom and carefully use it as a lever (only 2 mm deep).
v1.1 - The dimensions of the top part have been slightly reduced for easier closing and opening of the case.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
