Thingiverse
DS3218MG Servo Lever
10
Downloads
6
Likes
0
Makes
NON-COMMERCIAL USE ONLY! / KEINE KOMMERZIELLE VERWENDUNG!
This is a Servo Lever for the DS3218MG servo used in the Hanimandl project here and here. I designed this to transfer the force through the sides of the standard aluminum arm.
Replace the stock screw with M3x10 to attach it to the axis.
Fits a M6 bolt on the other end to attach a ball head.
There are at least two versions of the aluminium arm, 6.74mm and 7.44mm width. Make sure to print the correct version.
This is a Servo Lever for the DS3218MG servo used in the Hanimandl project here and here. I designed this to transfer the force through the sides of the standard aluminum arm.
Replace the stock screw with M3x10 to attach it to the axis.
Fits a M6 bolt on the other end to attach a ball head.
There are at least two versions of the aluminium arm, 6.74mm and 7.44mm width. Make sure to print the correct version.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!