DSO Shell 150 - Battery mod v3

This is an all-in-one enclosure for DSO Shell/Dso 150
Print the front part without support
Print the back part with support , they are not too hard to remove
0.2 mm recommended

You'll also need the following :
* 8 m3 screws (acrylic if possible)
* 2*m3 risers (acryclic if possible)
* m3 threading rod (dont use an electric drill, do it manually)
* Boost converter (MKTxxx)
* TP4056 battery charger WITH protection
* micro usb breakout board
* Switch
* Flat battery

I'm using my own custom firmware, that"s why there is a connector soldered to the SWD pins ( https://github.com/mean00/DSO_STM32Duino )

The enclosure is sturdier with older DSO 150 board.
There is one less screw hole with the newer board (bottom left on the pics)

This is a work in progress, i'm not happy with the BNC plate, by it is easy to change if you want to