Dual AMS Rack

Update 2/14/2026After some feedback from users I was able to add two additional mounting holes location for heat set inserts into the bottom rack support file. This will accommodate the new version of drawer slides available on the link below as well as some others commonly found. This build profile is under REV D Update 5/6/2025It is confirmed that this will also fit the first version of the AMS 2. I have test fit the new AMS 2 on the print with no interference issues. Update 2/4/2025I added a new profile that has built in AMS hub connector ports. you can order the connector adapters here as a set so that if the rack is set up between two printers the original cables will be able to reach each side of the rack hub port. There are two bulkhead ports on either side wall. The linked cables will act as extensions to each AMS unit and stay with the rack. The 24" cable on the bottom AMS to allow for in/out motion with the slides and the 15" cable to the top AMS just to re-locate to