Thingiverse
Dual Angle Phone Stand
door Nid3d
5
Downloads
2
Likes
0
Makes
The design offers two useful angles of support, easily swappable.
There are four flat recesses on the bottom for 6mm silicon feet.
A straight forward print. Slice standing on one side so no supports will be needed. Use a good brim base or even a raft. I used PLA+.
There are four flat recesses on the bottom for 6mm silicon feet.
A straight forward print. Slice standing on one side so no supports will be needed. Use a good brim base or even a raft. I used PLA+.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
