Thingiverse
Dual Cable Clip
by oglind_5399
0
Downloads
0
Likes
0
Makes
An easy to print cable holder/management design. Holds cables up to 5mm diameter.
can be used in a few ways, either with an M3x5.7mm threaded insert and a double sided adhesive on the back to stick it down.
Or because the base of the insert hole is thin, you could use it as a normal cable clip and put a screw straight through to secure it.
Great for things like networking cables or USB cables and can be used pretty much anywhere
No supports/rafts/brim required
can be used in a few ways, either with an M3x5.7mm threaded insert and a double sided adhesive on the back to stick it down.
Or because the base of the insert hole is thin, you could use it as a normal cable clip and put a screw straight through to secure it.
Great for things like networking cables or USB cables and can be used pretty much anywhere
No supports/rafts/brim required
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
