Thingiverse
Dual Engine Spaceship
von Kyle2023
0
Downloads
2
Likes
0
Makes
Drew up this design for my son who loves spaceships. Enjoy!
Printed on a Flashforge Adventurer 5m using a 0.4 Nozzle. I didn't tweak the settings in Orcaslicer, and kept the layer higher at .2mm. Normal supports were used, and ship was printed in a vertical orientation. These settings used 68.71 grams, and took 2 hours and 27 minutes.
Printed on a Flashforge Adventurer 5m using a 0.4 Nozzle. I didn't tweak the settings in Orcaslicer, and kept the layer higher at .2mm. Normal supports were used, and ship was printed in a vertical orientation. These settings used 68.71 grams, and took 2 hours and 27 minutes.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
