Thingiverse
Dual rotary encoder for simulator cockpit
von g0per
74
Downloads
39
Likes
0
Makes
Dual knob mount for radio management panels or Garmin autopilot panels. Designed for EC11 5 pin rotary encoders with round knob (parts grip by pressing on it).
Buttons on both encoders are not disabled, please note that the upper chassis (chassis2.stl) is 1mm thick on the button area, and either that panel should be replaced by your top cover, or you need to enlarge engranaje2.stl and tubofino.stl according to the added width if you mount the cover on top of it.
If you dont want to use the buttons, ignore the one on the mount and fill the hole for the small dedicated one. Dont remove the chassis2 spacers, they provide junction stability.
Youll need also:
* 16mm spacers: x4
* M3 screws: x8
* M3 nuts: x4
* M3 washers: x4 (on top of chassis.stl)
* EC11 rotary encoders: x2
Buttons on both encoders are not disabled, please note that the upper chassis (chassis2.stl) is 1mm thick on the button area, and either that panel should be replaced by your top cover, or you need to enlarge engranaje2.stl and tubofino.stl according to the added width if you mount the cover on top of it.
If you dont want to use the buttons, ignore the one on the mount and fill the hole for the small dedicated one. Dont remove the chassis2 spacers, they provide junction stability.
Youll need also:
* 16mm spacers: x4
* M3 screws: x8
* M3 nuts: x4
* M3 washers: x4 (on top of chassis.stl)
* EC11 rotary encoders: x2
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
