Thingiverse
Dual Spool Holder
door dragonflyRC
2
Downloads
3
Likes
0
Makes
These are the same pieces used in the Filament tricopter. Two tail pieces and motor mounts with 1/4" dowls.
This is was made because of carbon fiber eating the aluminum head on printer. In the video you can see spools resting to the rear of the printer. This feed the CF PLA at an angle so, it chewed in to the printer.
Now spools are held securely with a clamping of pieces and a bolt above printer.
Complete build at dragonflyRC.com
This is was made because of carbon fiber eating the aluminum head on printer. In the video you can see spools resting to the rear of the printer. This feed the CF PLA at an angle so, it chewed in to the printer.
Now spools are held securely with a clamping of pieces and a bolt above printer.
Complete build at dragonflyRC.com
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
