Thingiverse
Dual Z-axis alignment bars
von Coder-Tronics
2.2k
Downloads
1.1k
Likes
34
Makes
My Wanhao Duplicator i3 had a few frame alignment issues but nothing major. I found the frame where the Z-axis motors are would touch my table surface and the Y-axis frame would rock slightly (2-3mm) pivoting on the Z-axis frame pilars. If your frame is seriously out of align then other remedies will be needed, but the next part of the description has really worked for me.
Fitting feet to my frame improved this issue massively and made the whole frame feel very solid. I used a spirit level across the 2 Y-axis linear rods to level the whole printer, both back and front. Before this my hotbed springs were very misaligned in-order to get the hotbed glass flat and tuned to the X-Z axis gantry. These are the feet I am using
http://www.thingiverse.com/thing:1370173
After this alignment and a few other additions (see my other uploads) all the hotbed springs are almost identically aligned and bed trimming is easy and not necessary as often.
So this brings me to this new part, its
Fitting feet to my frame improved this issue massively and made the whole frame feel very solid. I used a spirit level across the 2 Y-axis linear rods to level the whole printer, both back and front. Before this my hotbed springs were very misaligned in-order to get the hotbed glass flat and tuned to the X-Z axis gantry. These are the feet I am using
http://www.thingiverse.com/thing:1370173
After this alignment and a few other additions (see my other uploads) all the hotbed springs are almost identically aligned and bed trimming is easy and not necessary as often.
So this brings me to this new part, its
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
