Thingiverse
DualShock Yoke for flight simulators
door akaki
919
Downloads
881
Likes
4
Makes
Snap-together yoke adapter for your playstation dualshock controller. No other hardware required.
See the video to see how to put it together: https://youtu.be/ylIe6uNZf6c
It will explain how to get good tolerance and sliding motion.
It is important to print the parts in the orientation shown in the screenshot. Especially the shaft, the bushing and the slate must be printed this way to slide well.
No support is required.
Perhaps you would also like my joystick adapters for PS4 and Xbox etc.: https://www.thingiverse.com/thing:4618312
And my arduino stand-alone joystick: https://www.thingiverse.com/thing:4576634
To clamp the yoke down, I used this awesome 3D printable clamp: https://www.thingiverse.com/thing:1673030
See the video to see how to put it together: https://youtu.be/ylIe6uNZf6c
It will explain how to get good tolerance and sliding motion.
It is important to print the parts in the orientation shown in the screenshot. Especially the shaft, the bushing and the slate must be printed this way to slide well.
No support is required.
Perhaps you would also like my joystick adapters for PS4 and Xbox etc.: https://www.thingiverse.com/thing:4618312
And my arduino stand-alone joystick: https://www.thingiverse.com/thing:4576634
To clamp the yoke down, I used this awesome 3D printable clamp: https://www.thingiverse.com/thing:1673030
akaki publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
![CadetYoke [3D-printed Flight Simulator Yoke]](/imgproxy.php?url=https%3A%2F%2Fmedia.printables.com%2Fmedia%2Fprints%2F41552%2Fimages%2F412584_0078e221-ffed-4c21-9124-93d4c5dd3469%2Flarge_display_20200823_194155_41552.jpg&w=400&h=300)
