Duchess Gaming Table Cupholder

For those who own the Duchess gaming table (which is no longer in production) but don't have any/enough cupholders, I have recreated the original swivel cupholders! However, these ones do NOT swivel; that would require extra hardware, including spring-loaded ball bearings, etc. More effort than I want to put into a simple cupholder just to keep drinks off the table. Instead, I have made 2 slotted pegs that are meant to act as pressure fittings; depending on variations of the hole placement on your table, you might need to sand these down a little bit.I printed the cupholder body in PETG, and the inserts in PLA; you can probably do both in PLA, just ensure you have a minimum 50% infill and 6 walls for strength.*NOTE: if you want to use the original metal inserts, the hole diameter of my print is juuuuuust a little too small. It didn't bother me because I'm using my own printed inserts, but if you absolutely must use the metal inserts, you'll either need to remix the hole