Thingiverse
Duet 3 mini 5+ Case
von Ekeberg
13
Downloads
8
Likes
0
Makes
This is a stand-alone casing for the Duet 3 mini 5+ controller board. It is designed to stand up vertically and has room for a 40x40x20 mm fan to ensure proper cooling. The fan should blow air outwards, so that cool air enters via the side-openings and passes both sides of the board.
The card exists in two versions: ethernet and wifi. Use the -box file for the ethernet version and the -wifi file for the wifi version. The lid is identical for both versions.
The case has a small slot in the back for fitting a miniature (11 mm wide) voltage step-down converter.
The board is fastened using four M4x6 screws. The lid is fastened using four M3x10 screws.
Disclaimer: I do not own this board (it is still not in production), so the details of the design are based on official photos/drawings. It is a modified version of my case for the Duet 2 Maestro (https://www.thingiverse.com/thing:4438555).
## Update 2020-12-30
Position of the holes for the reset button and indicator LEDs ha
The card exists in two versions: ethernet and wifi. Use the -box file for the ethernet version and the -wifi file for the wifi version. The lid is identical for both versions.
The case has a small slot in the back for fitting a miniature (11 mm wide) voltage step-down converter.
The board is fastened using four M4x6 screws. The lid is fastened using four M3x10 screws.
Disclaimer: I do not own this board (it is still not in production), so the details of the design are based on official photos/drawings. It is a modified version of my case for the Duet 2 Maestro (https://www.thingiverse.com/thing:4438555).
## Update 2020-12-30
Position of the holes for the reset button and indicator LEDs ha
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
