Thingiverse
Duet case
by iwant3d
3
Downloads
7
Likes
0
Makes
This is a case for the Duet 3d printer controller.
BOM
15mm nylon spacers (This allows space under the PCB for wires)
4x M3 screws to secure PCB
2 screws to secure the case
100 x 123 x 3mm acrylic sheet
Using acrylic lowers the print time and gives a really nice finish.
I just glued it to the inside of the case (see pics)
20% infill printed in PLA.
I used the screw terminals on the PCB so made the case slightly bigger than the board itself.
BOM
15mm nylon spacers (This allows space under the PCB for wires)
4x M3 screws to secure PCB
2 screws to secure the case
100 x 123 x 3mm acrylic sheet
Using acrylic lowers the print time and gives a really nice finish.
I just glued it to the inside of the case (see pics)
20% infill printed in PLA.
I used the screw terminals on the PCB so made the case slightly bigger than the board itself.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
