Thingiverse
Duet Wifi Case
von YogiG
311
Downloads
154
Likes
3
Makes
A case designed around the Duet Wifi, design choices were to focus on airflow while remaining svelte.
- Two 50mmx10 fans directing air over and above board. Channels to direct air under stepper drivers.
- Built in zip tie points along wall for cable management and two more in front to secure power and bed wires.
- Full rear panel access without having to remove anything.
- Reference notes recessed on inside wall for wire layout.
- Screws are threaded for M4-7 (10mm long is what I'm using)
- Two versions uploaded at the moment, one with feet and one without. I recommend supports for the bridge between the board and fans.
Thanks to the HEVO facebook group for being a great sounding board in laying this box out, much appreciated!
- Two 50mmx10 fans directing air over and above board. Channels to direct air under stepper drivers.
- Built in zip tie points along wall for cable management and two more in front to secure power and bed wires.
- Full rear panel access without having to remove anything.
- Reference notes recessed on inside wall for wire layout.
- Screws are threaded for M4-7 (10mm long is what I'm using)
- Two versions uploaded at the moment, one with feet and one without. I recommend supports for the bridge between the board and fans.
Thanks to the HEVO facebook group for being a great sounding board in laying this box out, much appreciated!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
