Duke Nukem 3D keycaps

This is a keycap with a hueforge of the Duke Nukem 3D logo on top of it! Use the available print profile to print it directly. But if you want to customize it, the Hueforge starts at 9mm, and then follows this : Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mmThe Model is 13x13mm in sizeYou may print at higher layer heights below the Min Depth of 0.48mmThe Max Depth is 1mm and the Actual Depth is 1mmFilaments Used: PLA BambuLab Matte Charcoal Transmission Distance: 0.1 PLA BambuLab Basic Blue Gray Transmission Distance: 2 PLA BambuLab Basic Orange Transmission Distance: 5.4 PLA BambuLab Basic Yellow Transmission Distance: 5.2This print uses 4 unique filamentsSwap Instructions: Start with Charcoal At layer #10 (0.52mm) swap to Blue Gray At layer #16 (0.76mm) swap to Orange At layer #21 (0.96mm) swap to Yellow for the rest.