Dumbbell

I took the screw section and sliced off the handle, replacing it with a tube for the handle and copy/pasted the screw end to make a Dumbbell.

95mm handle spacing which is enough for me and as a whole is just enough space to print upright on a Ender 3 v2

72mm screw length - my weights are a little over 52mm thick which with the nut leaves about 2mm left

Note:
I have yet to test print and test this (will do that tomorrow or so with petg as printing something else atm) - I have used the kettlebell with 7.5kg and it has handled that extremely well, also it's over a year old (still going strong as used Creality pla)

I don't have any small sized weights and have been using weights meant for a Bench press which are oversized for the Kettlebell but it fits and will be the same for this Dumbbell.
The Kettlebells handle is a tad small for me but still does the job, I wanted to see what a Dumbbell could handle and also petg been slightly stronger it seems like a good idea.


He