Dummy Door Knob

Do not rely on this door knob for anything. I won't recommend using it anywhere because of potential safety issues. I just designed it to see if I could. Settings I customized were going from 2 to 4 walls, changing the infill to gyroid, and adding tree supports. There's probably better settings out there, but I wasn't about to print again. I did also print each part separately, but I don't think that matters much. The middle cylinder only exists for both sides to have something to screw into and I was kinda surprised this was solid without immediately falling apart (though I did hear some concerning cracks). I used some drywall screws for this purpose. Since the knob is in the way, you kinda have to screw them in at a terrible angle. Did seal off the hole and makes it so I don't have to stick my fingers in it to open/close it, at least until I get a proper latching doorknob I like.