Dummy Unity Tactical FAST FTC Eotech G33 Mount

This project is mostly for my enjoyment, any feedback is greatly appreciated, especially with the print configuration since I mostly created the model and commissioned someone else to print it, I have 0 other 3D printing knowledge.

A dummy model meant for decoration on model guns. Can be flipped up or down.

Hardware needed:
- An M4x30mm screw and an M4 nut to attach the G33 mount to a picatinny rail
- An M4x30mm screw to attach the two halves of the G33 mount
- 2 M5x8mm countersunk screws to attach the G33 to the G33 mount, or use superglue if you have no intention of removing the G33 from the mount
The tall mount included is for Aimpoint T1/T2 pattern red dot sights, if you intend to print it then check the DripLyft riser below for more information

Adapted from the following models:
Unity Tactical FAST™ FTC Eotech G33 Mount
https://sketchfab.com/3d-models/unity-tactical-fast-eotech-6adc4ea9e71b47039fd6bb3d26419693
EoTech G33
https://makerworld.com/en/models/1484707-eotech-hhs-ii-s