Thingiverse
Duplicator i3 Camera Mount
von FloydDawg
1
Downloads
0
Likes
0
Makes
I just made some simple adjustments for easier printing (for me) and allowing for the Z brace mod.
Split in two, so it's not on the bed margins and also increased the height where it slides under the front brace, for those with the Z brace installed. This Z brace mod raises the printer to 10mm, so I allowed for that.
A great and simple design to start with. I made these small adjustments for myself and hope others fine them useful too.
Split in two, so it's not on the bed margins and also increased the height where it slides under the front brace, for those with the Z brace installed. This Z brace mod raises the printer to 10mm, so I allowed for that.
A great and simple design to start with. I made these small adjustments for myself and hope others fine them useful too.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!