Thingiverse
Duplicator i3 Filament Guide
door cultskunk
5
Downloads
4
Likes
0
Makes
This thing was made with Tinkercad.
Designed to mount to the side of your machine on the spare stop switch holes as filament guide if you use the bearing rollers for your filament etc.
Printing and testing to come.
-
Update - Printed perfectly fine and is currently in use. I did not like the way the cog came out though so i will either extrude it to make it come out or remove it all together. Purely aesthetics.
Everything fit as it should and my measurements were spot on from the holes to the alignment to the edge of the machine.
Designed to mount to the side of your machine on the spare stop switch holes as filament guide if you use the bearing rollers for your filament etc.
Printing and testing to come.
-
Update - Printed perfectly fine and is currently in use. I did not like the way the cog came out though so i will either extrude it to make it come out or remove it all together. Purely aesthetics.
Everything fit as it should and my measurements were spot on from the holes to the alignment to the edge of the machine.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
