Thingiverse
Duplicator i3 V1 Light Bracket
von Rangler6475
136
Downloads
80
Likes
3
Makes
6-8-16 update
I added different angles consisting of 140°, 145°, 150°, and 155°. I also added a cable management divot if you could call it that.
This light bracket comes in handy a lot. It uses a 12v led panel that is very bright. I tied it into the extruder cooling fan because it is always on, but I caused the cooling fan to run really slow due to lack of amperage provided by the power supply. Ended threading a 12v ac adapter wire throught the chain and running the fan off a wireless plug in the wall so I can turn it off and on.
http://www.ebay.com/itm/301032417732?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
feel free to comment
I added different angles consisting of 140°, 145°, 150°, and 155°. I also added a cable management divot if you could call it that.
This light bracket comes in handy a lot. It uses a 12v led panel that is very bright. I tied it into the extruder cooling fan because it is always on, but I caused the cooling fan to run really slow due to lack of amperage provided by the power supply. Ended threading a 12v ac adapter wire throught the chain and running the fan off a wireless plug in the wall so I can turn it off and on.
http://www.ebay.com/itm/301032417732?_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT
feel free to comment
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
