Durable Energy Sword

This is a build for a simple, durable Halo 4 (?) energy sword designed in Autodesk Fusion.

This design is completely from scratch, but MoeSizzlac's Energy Sword (https://www.moesizzlac.com/projects-HaloSword2.php) was a huge inspiration. Thanks Moe for being one of the most outstanding Halo creators out there!

Section 1: Electronics
The following non-printables were used for this project:
- 2M 5V COB Light Strip (https://www.amazon.com/dp/B0BXWRTNBL?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_13&th=1)
- Anker 5k mAh Portable Charger (https://www.amazon.com/dp/B01CU1EC6Y?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_12)
- Small on/off switch (Cannibalized from a motor controller - size is about 12x4x7mm)
- USB C to Micro SD adapter (https://www.amazon.com/dp/B07VBV1PY5?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_5)
- USB to DC adapter (any cord that can split a USB connection into Red-Black wires works)
Wiring is pretty simple. Each side of the blade uses just less than half of the 2M LED