Thingiverse
Dusk sensor enclosure
por roelnoten
2
Descargas
4
Likes
0
Makes
This is a dusk sensor enclosure. The main unit has holes for screws and the top slides on.
This is installed outside and is used to steer the orientation lighting in a house.
The circuit is a simple 741 opamp with 2 LDR's and a resistor divider where the opamp steers a transistor as switch.
The LDR's are installed in a tst tube which is glued in the enclosure with a lot of TEC7 (silicone glue) t ensure watertightness.
Note: the margins where to little so quite a bit of sanding was required to make the top slide on. This has been corrected in the STL.
This is installed outside and is used to steer the orientation lighting in a house.
The circuit is a simple 741 opamp with 2 LDR's and a resistor divider where the opamp steers a transistor as switch.
The LDR's are installed in a tst tube which is glued in the enclosure with a lot of TEC7 (silicone glue) t ensure watertightness.
Note: the margins where to little so quite a bit of sanding was required to make the top slide on. This has been corrected in the STL.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!