Dust extraction vacuum adapter customisable

This is a customisable adapter for connecting power tools to a standard 2.5" (35mm) vacuum extractor.

I have used this design with:

- Scheppach TS120o Table Saw (100mm)
- Ryobi Mitre Saw (64mm)

You can use a heat gun to soften the mouth of the adaptor if you have measured a little tight, and finish with a heat gun to get a good seal. I also recommend setting the inner diameter 1mm smaller than you want to ensure a snug fit.

Printing with TPU requires some adhesion, but you can get away without a support.

Github link: https://github.com/amadeuspzs/openscad/tree/main/dust-extraction-vacuum-adapter