Thingiverse
Dust remover
von Nudelsuppe
9
Downloads
4
Likes
1
Makes
A dust remover which pushes two sponges onto the filament using a thread.
This dust remover consists of two parts: top and bottom. After printing you must add a small piece of sponge to each part. With the sponges this tool will remove all the dust from your filament and will prevent cloaking.
This dust remover consists of two parts: top and bottom. After printing you must add a small piece of sponge to each part. With the sponges this tool will remove all the dust from your filament and will prevent cloaking.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!