Dustbin Latch Base - Roborock S6

The part will probably work with PETG or PLA+ as well. I'm not sure plain PLA would be strong enough. It should print in 10-15 minutes.

It looks a little rough because I have only learned MS 3D Builder. Sorry. Since it is working I thought it is time to finally give back even if it looks rough. I did this in about an hour so I would not have to order a $40 bin for my NEW Roborock from China. Support tells me even if a screw just falls out in the first two weeks of ownership, dustbins are a consumable you have to order from China.

I'm including the un-subtracted .3MF file so someone can more easily get dimensions if they wish to redesign. Just load it in windows 3d builder and click on the privatives for dimensions.

If your screw mounting posts are intact and you want to keep them, you will need to subtracts an approximately 5mm diameter by 2mm height cylinder from the bottom of the two holes. I melted 2mm heat sink inserts into my screw mounting posts. 2mm barely worke