Dutch Windmill Wall Decor

I wanted something to remind me of my trips to the Netherlands. Something I neglected to get when I was there a few years ago before the plague. Pretty simple to put together but the sails are best printed at a high resolution (mine are printed at .1 resolution) with no supports. The Main_Body and Cap are best printed with supports. I printed everything else without supports with no problems.

The Sails should fit snugly into the four slots, but a tiny dab of super glue might be needed to keep them in place. Look at the images for the correct placement. I inserted an MR52ZZ bearing in the Cap and used a 2mm screw through the Hub. Secure with nut (I used a piece of 3 mm silicon tube slipped over the screw from the back of the Cap as I was all out of 2mm nuts). Spins nicely with just a puff of breath.

The Main Body, Main_Mid, Main_Top and Cap parts are aligned with short pieces of 3mm rod and held together by super glue or some such adhesive. The Main_Top should be placed with the