Thingiverse
Dwarven Tower III
by TwoRoads
52
Downloads
29
Likes
0
Makes
Two piece print. I printed at .2 layer height with supports. Probably about a 36 hour print time between the two pieces.
The top could probably be printed upside down for slightly less support needed, but I wanted a smoother top.
This print has the top piece fitting into the bottom so they can stay two pieces. You could remove the bottom of the top piece if you just want to glue them together and make printing easier/use less support.
This is a remix, although the remix tool does not seem to be working at the moment so I can properly credit people.
https://www.thingiverse.com/thing:2760949
https://www.thingiverse.com/thing:3968634
https://www.thingiverse.com/thing:2958021
The top could probably be printed upside down for slightly less support needed, but I wanted a smoother top.
This print has the top piece fitting into the bottom so they can stay two pieces. You could remove the bottom of the top piece if you just want to glue them together and make printing easier/use less support.
This is a remix, although the remix tool does not seem to be working at the moment so I can properly credit people.
https://www.thingiverse.com/thing:2760949
https://www.thingiverse.com/thing:3968634
https://www.thingiverse.com/thing:2958021
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
