Thingiverse
DxCommander Guy Ring
door chopcat
23
Downloads
9
Likes
0
Makes
Having taken our DxCommander out in a bit of a wind a couple of things happened. When it blows about the SWR goes all haywire and under very testing conditions with the bottom guys only it can, and did snap on the bottom section. (easily mended with some cable clips)
So this ring sets out to add another spreader with some guy points
It has been testing over the weekend and looks as if it is going to do the trick.
You will need to fettle the hole so it sits on your mast where you want it.
Printed on Robo R2 with no particular skill
DE MØTDZ
So this ring sets out to add another spreader with some guy points
It has been testing over the weekend and looks as if it is going to do the trick.
You will need to fettle the hole so it sits on your mast where you want it.
Printed on Robo R2 with no particular skill
DE MØTDZ
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
