Thingiverse
Dyson Cable Holder
1
Downloads
0
Likes
0
Makes
Replaces the clip on the wand of a DC40 that the wire is wound round for storage.
To remove the original clip you need to pry the cover out of the centre of the part to reveal a screw and washer with a spring below. Remove the screw, insert the screw/spring/washer into the new part and screw back down.
The original screw cover cannot be re-used with the design as is.
To remove the original clip you need to pry the cover out of the centre of the part to reveal a screw and washer with a spring below. Remove the screw, insert the screw/spring/washer into the new part and screw back down.
The original screw cover cannot be re-used with the design as is.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
