Thingiverse
Dyson DC74 Latch Clamp
by mmccool
8
Downloads
2
Likes
0
Makes
Clamp to reinforce a Dyson fluffy (DC74) latch. This is not exactly a replacement part but a fix for a broken accessory latch. It still allows the latch to be used (to change accessories) after installation.
To be applied after gluing latch back in place; this clamp is to relieve the strain and keep it from breaking again (or, alternatively, from breaking in the first place... the design of the DC74 puts a lot of stress on the plastic around the latch).
To assemble this you also need two M3 x 15mm cap-head bolts and two M3 locknuts. Low-profile locknuts (3mm height) will end up being flush with the surface, but regular locknuts will also work. Regular nuts would work for a while but you might have to retighten the clamp occasionally.
Printed in PETG at 100% infill for strength.
To be applied after gluing latch back in place; this clamp is to relieve the strain and keep it from breaking again (or, alternatively, from breaking in the first place... the design of the DC74 puts a lot of stress on the plastic around the latch).
To assemble this you also need two M3 x 15mm cap-head bolts and two M3 locknuts. Low-profile locknuts (3mm height) will end up being flush with the surface, but regular locknuts will also work. Regular nuts would work for a while but you might have to retighten the clamp occasionally.
Printed in PETG at 100% infill for strength.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!