Thingiverse
Dyson Vacuum attachment
von Timbo3D
2
Downloads
1
Likes
0
Makes
Designed this because i needed this (to clean inbetween the radiators in my house).
It was designed to click right into the hose of a Dyson vacuum cleaner.
I added a full size version aswel as en split up version because the full version did not fit on my printer (Ender 3 V2)
I used pretty basic settings:
0.2mm layerheight
0.4mm nozzle width
0.8mm wall thickness
infill (gyroid) 10% (this seems like not much but the model is designed to have completely full walls at the parts that get a beating when used with these settings)
Dont forget to turn on supports everywhere for the slot that clicks into the hose (overhang angle 50°)
Hope this is usefull for some of you guys
It was designed to click right into the hose of a Dyson vacuum cleaner.
I added a full size version aswel as en split up version because the full version did not fit on my printer (Ender 3 V2)
I used pretty basic settings:
0.2mm layerheight
0.4mm nozzle width
0.8mm wall thickness
infill (gyroid) 10% (this seems like not much but the model is designed to have completely full walls at the parts that get a beating when used with these settings)
Dont forget to turn on supports everywhere for the slot that clicks into the hose (overhang angle 50°)
Hope this is usefull for some of you guys
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
