Dyson Wobbly Attachment Fixer

My Dyson attachments were all loose and wobbly in the end of my V10 handheld vacuum, which I found out was a common issue with age. So I designed this spacer that should push fit in to all* Dyson handhelds (Except the V6) to reduce lateral movement, I still found that there was some vertical movement and the fix for this is a few layers of painters tape (or I used a single piece of duct tape) on the attachment itself, behind the power connector. I have given STLs for 5 different spacings, from 0.6mm to 1.4mm, I found in my case 1.0mm was perfect. The 1mm model is 10mm high, so if you want a custom depth then you can just scale this in the Z as needed. Designed to be printed at 0.2mm layer height, should just push fit straight in as long as your printer is calibrated, if not then you may need to trim as there is very little tolerance. If using the STLs then duplicate the model and mirror on the X axis to provide the opposite side. Note: When removing this from the vacuum, gently pry eac