Thingiverse
e-bike controller housing
door zwieke
4
Downloads
5
Likes
0
Makes
A housing I made for my e-bike controller.
Fits a 54x31mm controller
308mm total height, but is printed in 2 pieces for ease of printing and ease of mounting.
You need 38mm of space between your downtube and fender/wheel to fit it.
I attached my fusion360 project file so you may change dimensions to fit your bike/controller.
Before using, please check your controller does not get too hot, as it might melt your plastic. For me it doesn't, so PLA is fine for my use.
Fits a 54x31mm controller
308mm total height, but is printed in 2 pieces for ease of printing and ease of mounting.
You need 38mm of space between your downtube and fender/wheel to fit it.
I attached my fusion360 project file so you may change dimensions to fit your bike/controller.
Before using, please check your controller does not get too hot, as it might melt your plastic. For me it doesn't, so PLA is fine for my use.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!