E-Flite Conscendo Evolution wing cover mount

Holds the wing and the fuselage together with four screws.

Print it vertically with the flat edge down.
Print extremely hot for the bed and nozzle for that first layer and make sure to enable brim and set it to at least 30mm.
Also print tree supports, organic if you can and for the best fidelity for the screw holes print at the lowest layer height you can go.

My settings are:

Layer height: 0.80 mm
Material: PETG
First layer Bed Temp: 90 C
Bed Temp: 80 C
First layer Nozzle Temp: 270 C
Nozzle Temp: 260 C
Supports: Organic, on build plate only
Brim: 30 mm
Retraction Length: 0.4 mm
Z hop when retracting: 0.3 mm
Z hop type: Spiral

Good luck!