Thingiverse
E-steps calibration template
von Rigge1988
22
Downloads
11
Likes
0
Makes
A template for marking up 100 and 120 mm (10 and 12cm) on 1.75mm filament.
I made mine from PLA but use your filament of choice.
I used supports and 3mm brim printed with the filament groove facing up. (is not preset).
Might have to clean the pencil holes post print,
Does not eliminate use of ruler or calipers to measure outcome. This tool will only help to get a firm mark on the filament. Make your marks on the infeed end.
Pencil holes are 1.75mm.
I made mine from PLA but use your filament of choice.
I used supports and 3mm brim printed with the filament groove facing up. (is not preset).
Might have to clean the pencil holes post print,
Does not eliminate use of ruler or calipers to measure outcome. This tool will only help to get a firm mark on the filament. Make your marks on the infeed end.
Pencil holes are 1.75mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!