Thingiverse
E3D Extruder Setup - Prusa i2
von kdmshark
193
Downloads
133
Likes
1
Makes
This is an entire low profile X-Carriage setup for a E3D V5 extruder. This X-Carriage setup will allow the hot end to mount with enough clearance for the bearings and still have the capabilities for auto bed leveling.
6/22/14
- An E3D V6 version has been made and all parts are the same except for the Extruder Mount and Mount Lock.
- X-Carriage nut traps redesigned for more strength.
6/23/14
- All parts out of work in progress and tested.
If you make this please provide me feedback so I can improve on the design! Enjoy!
6/22/14
- An E3D V6 version has been made and all parts are the same except for the Extruder Mount and Mount Lock.
- X-Carriage nut traps redesigned for more strength.
6/23/14
- All parts out of work in progress and tested.
If you make this please provide me feedback so I can improve on the design! Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!