Thingiverse

E3D Heater Block Micro Z-Probe

by jimustanguitar

46 Downloads

25 Likes

1 Makes

Go to Model

I designed this bracket to snap on to an E3D-V6 heater block and to hold a tiny microswitch as a Z-Probe for calibration. (switch source http://www.goldmine-elec-products.com/prodinfo.asp?number=G16909 )

Wire up a disconnectable harness, and just snap the bracket on and off when you want to run a calibration cycle.

Note that the STL file has printed support built into the model. The STL file contains 3 separate pieces.

Don't use the bracket while the hot-end is hot.

Autolevel Probe Mount designspark mechanical dsm2 E3D e3dv6 E3D_ E3D Hotend E3D v6 microswitch microswitch_ MicroSwitch Bracket probe snapswitch TheMakerhive z-probe z probe

Source

Thingiverse

What you need to print this: Beginner Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format