E3D ToolChanger - Toolhead LED Illumination

I made a little holder to put a LED strip underneath the toolhead, so i got the light where i need it.

It is a simple and easy printable part, which clicks onto the the spacers.
The cable can be laid as the cable from the endstop.
You only need two additional wires going to the toolhead and plug them into the F0 fan connector.

I run the LED on 25% PWM to keep the temperature low.
(M106 P0 S0 X0.25 B0 C"Light")

The LED strip can be found here:
https://www.conrad.de/de/p/tru-components-tru-ledmo-14-24-ww-highpower-led-modul-eek-a-a-e-mit-loetanschluss-24-v-50-mm-warm-weiss-1582410.html