Thingiverse
E3D V6 Hot end Mount for Ormerod
door Cola
135
Downloads
69
Likes
3
Makes
Mount for ED3's V6 all metal hot end for RepRapPro's Ormerod 3d printer. It is a direct replacement for the standard Ormerod hot end. No Z axis height is lost switching to this mount.
The assembled hot end with a 11x40mm fan installed measures 42x40mm and weighs 83g. The Stock Ormerod Hot end with it's 20x40 fan Measures 52x58mm and is 96g. A 35% infill was used for both hot end's printed parts. The V6 assembly is both smaller and lighter then the standard Ormerod hot end.
I have had no issues in testing. Printing at 180c for PLA there was no visible effect on any of the mount parts. I have not printed any ABS, however I kept it at 250c for 1 hour and there was no visible change on the PLA mount, however I still suggest printing the mount in ABS if you will be using higher temps.
The assembled hot end with a 11x40mm fan installed measures 42x40mm and weighs 83g. The Stock Ormerod Hot end with it's 20x40 fan Measures 52x58mm and is 96g. A 35% infill was used for both hot end's printed parts. The V6 assembly is both smaller and lighter then the standard Ormerod hot end.
I have had no issues in testing. Printing at 180c for PLA there was no visible effect on any of the mount parts. I have not printed any ABS, however I kept it at 250c for 1 hour and there was no visible change on the PLA mount, however I still suggest printing the mount in ABS if you will be using higher temps.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
