E3D V6 Single Direct Drive System

EDIT 2/1/17 Added the mounting plate to use this extruder on a D-bot CoreXY

EDIT 6/6/16 Added new version of the idler. This new idler has support for the bearings on both sides so it can't bend over and lose clamping pressure on the filament.
There's a 0.4mm thick support material built in that you must cut out. No support needed from your slicer. Use a washer on BOTH sides of the roller bearing. Low profile nut of course.


-----------------------------------------------------------------------------------------------
Don't let the long parts list intimidate you on this build!!

In reality, all you need is a bunch of long M3 screws, and a Dremel tool to cut them to the proper length.

Below is a bill of materials with links to each non-printable part. These are bags/lots of each item. Most are like, 25, or 50 of each. You only need a few of each one though. I used these links for two reasons. 1. I did order these packs because I do a lot of work with these pa